8
GENERATOR SET-UP
The following section describes steps necessary to prepare the generator for use. If after
reading this section, you are unsure about how to perform any of the steps please call Global
Industrial Customer Service at 1-800-645-2986 or visit www.globalindustrial.com. Failure to
perform these steps properly can damage the generator or shorten its lifespan.
Step 1 - ADD OIL
User must add the proper type and amount of oil before operating the generator. Failure to do
so could result in engine damage.
Place generator on a level surface.
Verify oil fill area is clean.
Remove oil fill cap and wipe dipstick clean.
Add recommended engine oil as shown in the below chart.
Thread dipstick into oil filler neck. Oil level is checked with dipstick fully installed.
Remove dipstick and verify oil level is within safe operating range.
Reinstall oil fill cap/dipstick and hand-tighten.
Summary of Contents for 716173
Page 20: ......