35
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
❑
Set the canopy into place and align it over the molded
cockpit area.
❑
When satisfied with the alignment, install and tighten two
2mm x 5mm wood screws, threaded through the canopy and
into the fuselage, to hold the canopy in place.
☞
Use the tip of your modeling knife to make small pilot
holes in the canopy and fuselage.
❑
Pacer Z-42 Threadlocker
❑
.050 Hex Wrench
❑
Wire Cutters
❑
Adjustable Wrench
❑
Excel Modeling Knife
YOU'LL NEED THE FOLLOWING PARTS:
❑
(1) 5 x 2.5 Nylon Propeller
❑
(1) Threaded Shaft Adapter Assembly
❑
(1) Spinner Assembly - Front & Back
SECTION 14: FINAL ASSEMBLY
❑
(1) Double-Sided Foam Tape
❑
(1) Decal Sheet
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
❑
Scissors
❑
K&S 30 Watt Soldering Iron
❑
Heat-Shrink Tubing
❑
Solder
Step 1: Installing the Propeller & Spinner Assembly
IMPORTANT
When installing the threaded shaft in the next procedure, we
strongly suggest applying thread-lock to the set screw. This
will prevent the set screw from loosening during flight.
❑
Slide the threaded shaft adapter onto the motor shaft and
tighten the set screw using a .050 hex wrench.
☞
Make sure that the back of the shaft adapter does not
rub against the front of the motor plate.
Step 2: Installing the Canopy
❑
Remove the hex nut and washer from the threaded shaft adapter.