10
Need help or have any questions? Call us at 1-714-963-0329 or send us an email to [email protected]
❑
Using a modeling knife, carefully cut out the wing saddle
along the outline you drew.
☞
Instead of trying to cut through the plastic in one pass,
it's easier to make several shallow cuts. It also helps to use a
very sharp knife blade.
❑
Using a modeling knife, carefully cut away the molded
"button" flush from the front of the fuselage.
❑
Using a modeling knife, carefully cut open the air-intake
scoop below the motor mounting area.
❑
Hold the motor mounting plate against the front of
the fuselage, centering the outer edge of the plate with the
outer edge of the fuselage.
❑
Using a modeling knife, carefully cut two 1/8" wide slots
from the center hole out beyond the two marks you drew.
☞
We do not suggest drilling the two motor mounting holes.
They are so close to the center hole that keeping them aligned
while drilling will be difficult.
❑
While holding the motor mounting plate in place, use a pencil to mark the locations of the two mounting holes onto the
front of the fuselage.