Manufacturers of Fire Detection Equipment
globalfire.pt
GFE-TCP-WEB -
CONFIGURATION MANUAL - 11/2017
Manual Configuration: Procedure
Execute below commands to configure network and web-server parameters:
NOTE:
Disable the DHCP Client:
wdhc=0
and press ENTER
Set Network IP:
wip4=xxx.xxx.xxx.xxx
and press ENTER
NOTE:
> If you want to configure DHCP again enter the following command:
wdhc = 1
and press ENTER
IP address, Subnet Mask and gateway must be introduced in its complete form, including zeros on the
left (ex: 192.168.001.020)
'Client ID' and 'CHANNEL 1' parameters are necessary during webpage configuration steps.
>
>
> Set SubNetMask:
wsu4=xxx.xxx.xxx.xxx
and press ENTER
> Set Gateway:
wga4=xxx.xxx.xxx.xxx
and press ENTER
> Set Channel 1:
wch1=xxxxx
and press ENTER (
Note: channel name must have 5 characteres).
With command '
rdat=
' it's possible to check all sent parameters which can be redefined individually. Please find below
screenshots of above steps and 'rdat=' commands.
After sucessufully completion of above steps, disconnect USB cable, connect GFE-TCP-WEB interface to desired panel and
network cable.
