34
/
48
1.
Powering On/Off and Battery Indicator:
To turn the scooter on, you must press the
on/off switch as shown below
(S) once
. The Battery Indicator LED Light (
S1
) will indicate
the power is on by lighting. If all 3 lights are on, it means the battery is at least 50% full. If
only 2 lights are on, battery is below 50%. If only 1 light is on, battery is approaching
empty and may have 1 mile left. Note: the battery indicator light is accurate only when the
throttle tab (
S2
) is NOT engaged. When throttle is pressed, the reading could be LOWER
than actual as the instant current will alter the voltage reading from battery. If the LED is
not lit, the scooter is turned off. The scooter will automatically turn off after five minutes of
non-use.
To turn the power off, you must press the on/off switch and hold it for at
least 2 seconds
.
The scooter is on electronic braking when power is on and if the
right accelerator is not pressed. If you need to push the scooter manually, turn off the
power.
2.
Headlight On/Off:
To turn the headlight/tail light on or off, you must first turn on the
scooter power (S). While the scooter power is on, press the power button (S) once, the
headlight and rear light should be turned on. Press (S) one more time, the headlight & rear
light will be turned off.
3.
Accelerator:
The right thumb control is the accelerator (S2). The further you press the
accelerator down, the more energy you will release to the motor.
NOTE
:
As a safety
feature, the motor will be in the default “braking” mode when the LED is on and
when the accelerator is not pressed
. Read below “Speed Setting Controls” to understand
speeds. Operate your SNAPnGO at a reasonable speed for both your personal safety and
others.
CAUTION
–
Do not make turns at high speeds or on steep inclines. Your
SNAPnGO may tip over.
4.
Reverse control:
The reverse control (T1) is located on the left side. When switch is
forward set to F position, it means forward. When switch is set to R position, it means
reverse. The reverse mode has a top speed of 2-3mph and does not change speed
regardless of speed setting. If the scooter is on reverse mode, scooter will move backward
when throttle (S2) is pressed.
Summary of Contents for SNAPnGO 335
Page 27: ...27 48...
