Installing Your Water Heater
1. The appliance must be installed in compliance with current local regulations.
2. Mount the water heater vertically on the wall by fixing the 3 bolts (1/CX2”)
3. Connect the inlet to the cold water of the mains by means of a 1/2” BSP female
pipe fitting.
4. If the operating pressure in the water heater is above 6.5 bar (95p.s.i.) fit a pressure
reducing valve.
5. Connect the outlet pipe of the appliance to the hot water supply system by means of
a 1/2” BSP pipe fitting.
6. Care to be taken to avoid damage caused by applying excessive force while
connecting
Electrical Connections
•
Refer wiring diagram to check electrical connections. Ensure proper earthing at 3 pin
supply point.
1. Cut-out
2. Indicator Lamp Red
3. Thermostat
4. Indicator Lamp Green
5. Heating Element
Note : Main’s cord or any other electrical component must be repaired/replaced by
authorized service personnel only. Minimum contact separation of 3mm is required
in all poles for disconnection
Mains Cord : 48/0.2 (1.5mm
2
) 3.0 KW.
80/0.2 (2.5MM
2
) for 4.5 KW
Instant Water Heater Manual.indd 3
9/19/2019 6:06:52 PM
