Rotisserie motor will not turn
--Check the voltage at the outlet.
If an extension cord is required, ensure it is a 16
gauges, grounded cord.
Ensure the on/o
--
--
ff switch is on.
--
r drag.
--Ensure the load does not exceed the 40 pounds
operational capacity.
--Ensure the spit is fully inserted in the motor.
Ensure there is no encumbrance o
Grill
only
heats
to
200-300
degrees.
sure the temperature gauge is functioning
properly. Hold a flame to the probe or compare the
eter place in the
--
cedure. Prior to lighting
f. The
the way on.. Turn left burner
t for
--En
grill gauge to an oven thermom
grill.
Ensure correct start pro
grill, the gas control knobs should be of
propane bottle should be off. If not, wait 15
minutes. Turn tank all
to ignite, wait 5 seconds ignite. Repea
additional burners.
--Check all gas connections for leaks with bubble
test. If leaks are found, replace the part or tighten
the fitting.
Grill takes a long time to preheat.
--
--Normal preheat 500-600degrees, takes about
10-15 min. Cold weather and wind may effect your
preheat time.
If you are using volcanic rock or briquettes they
can increase the preheat time and maximum
temperature.
Burner flames are not light blue.
n affect the mixture. Burner adjustment
may be required. Refer to manual for adjustment
--Too much or not enough air mixes for the flame.
--Elevation is the principal cause, however cold
weather ca
procedures.
--Grill is in a windy location.
21
