DI/ML COOKER SERIES DOOR REMOVAL AND
INSTALLATION INSTRUCTIONS
The new DI and ML series of Glem and Emilia cookers have
the latest oven door hinge design technology from Glem
Gas. For the removal and re-installation of the oven door
with the new hinges please follow these procedures.
STEP 1 OPEN THE DOOR FULLY
STEP 2. LOCK THE TWO HINGES
STEP 3. REMOVE THE DOOR
The door removal has to be done with the door open at an
angle where there is 150mm gap at the top.
THIS IS
IMPORTANT
1. Using a kneeling position grip the door as shown
DO NOT pull on the handle
2. Close the door slightly until there is a gap at the top of
150 mm. THIS IS IMPORTANT
3. Lift the door in the direction of the arrow
4. Pull the door away from the cooker towards you in the
direction of the arrow. The most pull should be at the
lower part of the door. One side may release first, do
not force the door.
TO RE-INSTALL THE DOOR
NOTE - ONCE YOU HAVE INSTALLED THE DOOR IF IT
DOES NOT OPEN PROPERLY REPEAT THE PROCEDURE.
DO NOT FORCE THE DOOR AT ANY TIME.
IMPORTANT Hold the door at an angle so there is a
150mm gap at the top.
Hook the hinges in first with the groove in the bottom of the
hinge sitting on the roller housing.
Once the hinges are located properly fully open the door
again and unlock the hinges and close the door.
IF THE DOOR DOES NOT OPEN FULLY AFTER THEN THE
HINGES HAVE NOT BEEN LOCATED PROPERLY. REPEAT THE
PROCEDURE. DO NOT FORCE THE DOOR.
11
Using your finger or a
screw driver
rotate the locking
bracket
Hinge in normal
position
Hinge in locked
position
OPEN
150 mm
LIFT UP
PULL