405-OM-UK-001 v1.0
–
09 Jul 2020
Need assistance? +44 (0)1379 658300 [email protected]
Page 7 of 18
Controls and Operation
Various options are available at time of order. If specific data is required for your product, please refer to your order confirmation or
contact your supplier for assistance.
Control Switch
The standard operation of the unit is via the supplied wall mounted control switch and can be operated using two different methods
as explained below:
Figure 1
–
Wall mounted control switch
‘One touch’ operation
–
Press and release the control switch once in either the up or down direction - the product will open or close
fully. Partially open positions can be achieved by pressing the control switch again at any point during the open or close cycle.
Conventional
‘hold’ operation
–
Press and hold the control switch until the product has reached the desired position, releasing the
switch stops the product in that position. Note that the product will stop automatically when it becomes either fully open or closed.
Status Light
The status light will illuminate green if the product is functioning normally. If the status light displays another colour, please refer to
the troubleshooting section of this document.
Remote Control (Optional)
The remote control unit functions in the same way as the wall mounted control switch but allows you to open and close your product
from a short range. It has 3 control buttons, open, stop and close - the stop button can be used for partial opening.
The remote control is powered by 2 x AAA batteries. In order to preserve the battery, the remote control will switch itself off after a
brief period of inactivity. It will switch itself on when any of the buttons on the remote control are pressed. To replace the batteries,
remove the small hex screws found on the rear of the remote to allow access inside. Note the polarity when inserting the new
batteries.
Figure 2
–
Remote control
Status light
Status light