203-INST-UK-001 v1.0
–
02 Aug 2022
Need assistance? +44 (0)1379 658300 [email protected]
Page 12 of 21
Before fitting the product into the opening, use masking tape to attach the supplied plastic packers (supplied) along the jambs and
cill as shown in figure 6a. To ensuring that the product will sit centrally in the opening, there should be a nominal 10 mm gap on all
round. Ensure that these will not conflict with the fixing holes in the product.
Figure 6a
–
Tape plastic packers along jambs and cill
Lay a continuous strip of butyl tape (supplied) onto the underlay hard up against the internal aperture as shown in figure 6b.
Figure 6b
–
Continuous loop of butyl tape applied on top of underlay
Fit the chosen lifting equipment to the unit and check that it is secure. Glazing Vision suggest using glazing vacuum lifting equipment
for ease of installation.
Once lifting equipment is attached to the section, carefully remove the transit frame/blocks.
Glazing Vision suggest lifting the sections at the same pitch/angle as the installation, as this will help with the install.
Then gently lower onto the supporting structure.
Butyl tape
–
hard
up to aperture on
all sides
