Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9720
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
2
t
roubLe
S
hooting
t
he
S
oDa
S
yStem
C
onDition
C
auSe
r
emeDy
1. No soda or water at valve.
(a). Water supply interrupted.
(a). Check if valve open.
(a). Check water pressure
(b). Frozen water bath.
(b). Replace ice bank control.
(c). Valve power interrupted.
(c). Check electrical circuit.
2. No syrup at valve.
(a). Product tank or BIB
(a). Re-connect.
connector not in place.
(b). Low CO2 gas pressure.
(b). Replace cylinder.
(c). Tank dip tube “O” ring.
(c). Return tank to bottling plant.
3. No Carbonation.
(a). CO2 gas supply depleted
(a). Replace cylinder.
(tank volume gauge in the red).
(a). Replace cylinder.
(b). Carbonator unit not operating.
(b). Consult Service Tech.
4. Product foaming on one valve.
(a). Booster gas pressure too high.
(a). Re-adjust.
(b). Syrup supply almost depleted.
(b). Replace tank or BIB.
(c). Brix too heavy.
(c). Adjust brix.
5. Product foaming on all valves.
(a). Booster gas pressure too high.
(a). Re-adjust.
(Common regulator)
(b). Product tanks or BIB stored
(b). Product tanks or BIB
in cold ambient temperature
should be stored in room
and are absorbing CO2.
be stored in room temperature.
t
roubLe
S
hooting
t
he
r
efrigeration
S
yStem
C
onDition
C
auSe
r
emeDy
1. Refrigeration unit not operating.
(a). Power supply interruption.
• Blown fuse.
• Replace
• Circuit or area-wide failure.
• Check power plug and outlet.
(b). Compressor will not start.
• Defective overload protector.
• Check, and replace if necessary.
• Defective starter relay
• Check, and replace if necessary.
• Internal motor winding fault
• Replace compressor.
(c). Condenser fan not running.
(Should operate with compressor)
• Wiring connection fault.
• Check circuit and repair.
• Burnt motor winding.
• Replace motor.
2. Refrigeration unit operates but
(a). Condenser is plugged with dirt.
(a). Clean with a brush.
does
not cool.
(b). Freon gas leak, (gauge shows
(b). Locate and repair.
vacuum pressure reading on suction side).
(c). Agitator motor not operating (should
run continuously).
• Shaft jammed.
• Adjust alignment.
• Wiring connection fault.
• Check circuit and repair.
• Burnt motor windings.
• Replace motor.
3. Water bath frozen.
• Defective cold control.
• Replace control.
4. Noise in water bath.
• Water level too low in water bath.
• Fill to proper level.
t
roubLe
S
hooting
