GlammFire.
PAG./24
6.8—Battery charging
When charging the battery, you should follow the following process:
• Disconnect the system battery connector, located next to the “ON/OFF/ON” button (
Figure
7
).
• Remove the battery.
• Connect the battery connector to the charger, as shown in
Figure 8
.
Connect the battery charger to an electrical outlet plug.
A red light will light up on the charger, indicating that it is charging.
The battery will take about 10 hours to recharge. After recharging the battery, you can assem-
ble it in the system following the same process in reverse.
Figure 7
—System battery connector location.
Figure 8
—Connect the battery connector to the char-
ger.
7—Security Systems
Whenever there is some kind of error, it appears on the display. Simultaneously, the system
emits one continuous beep.
The error remains on the display until you click on the
"OFF"
button (on the display) for 2-3
seconds. After clicking the button, the system emits one beep that indicates the elimination of
the error. As this action can not be realized by remote control, is always guaranteed the visu-
alization of the error occurred.
