8
5.Bass EQ
This is variable control to increase the Bass EQ at 45Hz from 0dB ~ +18dB of gain, adjust
to suit.
6.Remote Bass EQ Control/ Gain Control
- Bass EQ Control
This port allows connection to the remote bass control (Optional). When plug in the remote
control, set BASS EQ Gain to MAX( +18dB) position and then, adjust the remote BASS
Control.
- Gain Control
Instead of a fixed level adjustment with the control GAIN the remote control can be used for
variable level adjustment. Thus, it is possible to boost or attenuate the bass frequencies
accordingly depending on the music material.
Mount the remote control within the driver
’s reach. Connect the cable to the jack
REMOTE CONTROL. Thus, the contol GAIN without function.
7.Low Pass Variable Controls (LPF)
Set crossover switch to Low when a subwoofer is connected. Ensure the crossover
frequency is set at 100Hz or below, this designed to filter out all mid to high frequencies that
only FULL RANGE speakers should produce.
※
Note: Failure to do so could result in speaker damage.
8.Subsonic Filter
It allows high pass of frequency between 20Hz and 50Hz.
9.Power LED (Blue)
This shows if the amplifier has been correctly powered up.
10.Protection LED (Red)
This shows if any faults are present
11.RCA Line Input Jacks
Connect these RCA connectors to a head unit with a LOW LEVEL output connection
12.RCA Line Output Jacks
Use these RCA output connectors to connect to a secondary amplifier. This output is
PASS-THRU connection derived from RCA input connector so the signal level and
frequency response is the same as the original input signal. .
13.Power Input Connection
This must be connected to the battery positive (+) terminal via 18mm or higher gauge
power cable and with an inline fuse or circuit breaker at the battery end.
※
Note: This is to be the last wire to connect up during installation as damage could result.
14.Grond Input Connection
Connect directly to the battery negative (-) terminal via 18mm or higher gauge power cable.
※
Note: This is to be the first wire to connect when wiring up a amplifier damage could
result if this is not done
Summary of Contents for 10.0K
Page 1: ...1...
