7
CONTROL AND DESCRIPTIONS
Features and controls
1. RCA In/Out Jack for Daisy Chain
Connect the input of the MASTER to a suitable source, e.g. a head unit with good quality
RCA cable and connect the MASTER OUTPUT RCA jack to the corresponding RCA jack
on the SLAVE amplifier.
And then, select MASTER/SLAVE switch properly.
2.Master/Slave Switch
Two amplifiers can be connected together and bridged into a single (2Ohms Min.) load.
One amplifier will be assigned as MASTER and the second will be assigned as a SLAVE.
※
The level and filter frequency controls on the SLAVE will be disabled, as the MSATER will
control all function.
3.Phase Change Variable Control
This is related to time delay effect, thus the phase adjustment on subwoofer will correct
phase by bringing the low frequency from the rear of vehicle to the front. And this will tend
to create a more realistic front stage at the low frequency.
4.Input Gain Control
This allows adjustment of the input signal. Use this control to correctly match the head unit
to the amplifier. To set this control correctly, turn the amplifier levl to MIN and the head unit
to 3/4 volume, with BASS and TREBLE on zero, then slowly turn up this amplifier level
control towards the MAX end of the control.
※
Note: If sound becomes distorted, turn this control down.
Summary of Contents for 10.0K
Page 1: ...1...
