9
10
Power lock
and Back-up
Battery lock
(do not open it till power failure)
Open to clean
the Condenser
filter net
Inner door
Cabinet inner
seal
Test port
Shelves
Shelves frame
Outer door
seal
Inner door
seal
Just to switch on the power supply for
medical freezer
do not immediately add items, make empty operation after a
period of time (about 24 hours), then refrigerated goods into storage box.
To add items, if the item is too much water or excessive drying will influence the change of the humidity, the best
goods sealed; the same
medical freezer
working environment humidity size will also affect the change of the humidity
of the door and the door body ,especially too much not close well.
For each store items can not exceed 1/3 box capacity, achieve the actual temperature and normal operation after 24
hours, then add another 1/3 box storage capacity.
To add items please do not block the outlet and inlet.
The goods can not be placed directly on the bottom of the
medical freezer
should be placed on the bottom shelf,
otherwise the effect of
medical freezer
cooling effect.
The cooling process as far as possible not to open the door, otherwise it will cause temperature rise.
Due refrigeration inertia, the product reaches a set value when stopping the display temperature and the set temperature
may have a certain difference
, this is the normal phenomenon.
Note: children are not allowed to play games in a
medical freezer
.
Caution
For personal safety, please cut the power supply before any maintenance!
Don't inhale medications or aerosols around the device while maintaining a
medical freezer
, or it
will endanger
your health.
7
.
Defrost
●
Unused
●
Maintenance
After the product has been working for a period of time, its internal surface will be frosted, which will affect the
cooling effect and increase the power consumption. It is recommended that defrosting should be performed when
the frost layer is too thick.
Cut off the power, open the door, and transfer the items to a cool place.
Use a defrost scoop to gently remove the surface area cream (Also allow the temperature inside the tank to
naturally rise, melt the frost)
In order to speed up the defrosting process, flat bottom containers with less than 50°C hot water can be placed in
a medical freezer.
Then use a dry cloth to wipe off any remaining ice water. Return items to the medical refrigerator.
Power on, power on cooling.
7.
1 D
efrost
Warning: Do not use sharp metal appliances during defrosting to
avoid damage to the medical freezer.
7.2
U
nuse
d a
n
d M
aintenance
If the product needs to be stopped for a long time, the power should be cut off, cleaned
according to following methods, and sealed after opening and drying.
Before using it again, apply a dry cloth to dry the water around the door.
