7. Allow the water to fill the empty reservoirs.
8. Wait 10 minutes then turn energy saving switches OFF and unplug the power cord.
9. Place a 2 gallon or larger bucket under the drain plug in the rear of the dispenser.
10. Remove drain cap and silicon plug. Cold water will immediately flow into the bucket.
Several seconds later hot water will dispense.
Reminder - Place drain cap and silicon plug in a safe location so they are not lost.
11. Once unit has drained, replace silicon plug and drain cap.
12. Remove remaining water from reservoir by dispensing from the cold tap into a
pitcher.
13. Return the unit to its location, install a fresh water bottle, plug the power cord back
into the grounded wall outlet and turn the energy saving switches ON.
HOT WATER
14. Display shows time of the day, every 30 seconds it will flash time of next self cleaning,
When self cleaning occurs it will flash words: “SELF CLEANING” Display time setting.
15
.
How to switch Off Beeping signal:
Bottle icon on the display will flash and beep when bottle is empty.
To turn beeper off touch for 3 seconds words on the panel marked BEEP ON/OFF
Beep ON or OFF markings are shown here.
Display’s Operation explanation
SET the clock
•
System just electricity, the clock default from 12:00 PM start
the timer.
•
Hold SET key for 3 seconds until hours digital started to flash.
•
At this time to press the buttons ADJUST can adjust an hour,
continued hold can quickly setting hours Numbers.
•
SET to complete press SET key sure to save, then minutes
digital started to flash.
•
At this time to press the buttons ADJUST can adjust a minute, continued hold can
quickly set up minutes Numbers.
•
SET to complete and press SET key sure to save, withdraw from the clock SET
condition.
•
The clock will correct operation, unless the machine power supply to be cut, the
clock will return to 12:00 PM start the timer.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 888-828-1426 for assistance.
14
