M1000002 V1.2 - 11/2021
www.gkdtechnologies.com
12
7 INITIAL SETUP (CONT.)
7.2
Machine dimensions with Boom Ram pulling from above the Stub Boom Pin
Measure and record the vital machine dimensions X1,
X2, Y1, Y2 in mm as shown below.
7.3
CAN Bus Connections
Connect the USB to CAN Converter interface to a USB
port of a PC and through an M12 “T” connector into
the CAN bus of the Series 1-L system. This ensures that
the Angle Sensor M12 connection is still made during
the set-up and calibration process.
IMPORTANT NOTE: ENSURE USB DRIVERS ARE
INSTALLED FOR THE USB TO CAN CONVERTER. SEE
APPENDIX - GKD USB DRIVER INSTALLATION NOTE.
Apply power to the Series 1-L System.
Stub Boom Pin
Ram Chassis Pin
X1: Typically
-280mm
X2: T
ypically
+1450mm
Y2: Typically
+760mm
Ø
Y1:
Typically
+430mm
Machine dimensions with
Ram pulling from above
the Stub Boom Pin.
DISTANCES BETWEEN
STUB BOOM PIN &
RAM CHASSIS PIN ARE
NEGATIVE DOWN OR
BACK.