GKB HZ2001 HD-SDI PTZ Camera
10
Connect cables to hole of pin. Insert the pin inside the back box. When finished, close the door to
the back box and turn on the power. The LED will light up. See Pic. 5.
"
If the LED does not light up, refer to Section
0
: 4. Trouble
Shooting
.
Step 2.
Install dome drive
Pic. 6
Set the DIP switches for SW1 and SW2 at the bottom of the dome drive for the appropriate receiver
address, communication protocol, and baud rate. Refer to the labels on the dome drive or DIP
SWITCH SET at the beginning of this manual.
Remove cover of camera and sponge. See Pic. 6.
Pic. 7
Line up link card and faucet of the back board of the dome. Push the dome drive in. See Pic. 7.
