10/06/2008
M042.E
GQ
•
28
¥
72
press
The display will reset.
Place the axis in the final
point of the next segment.
4 0 0 . 0 0
®
X
Enter the real measured value of displacement.
In our case the real value is:
399.88 mm.
3 9 9 . 8 8
®
X
press
The display will reset.
Place the axis in the final
point of the next segment.
0 . 0 0
®
X
or press
To quit the programming.
S E G.C. yes
®
X
Complete the selection on every axis of the readout (X,Y,Z and W).
Ø
THE CORRECTION
IS PERMANENTLY STORED (IT BECOMES A MECHANICAL
COMPONENT OF THE AXIS WHICH HAS BEEN ACTIVATED)
AND IS BOUND TO
THE
REFs.
Ø
IN ORDER TO CORRECTLY OPERATE, IT IS ALWAYS NECESSARY TO MAKE
THE SCALE REF SEARCH ON THE AXIS ON WHICH CORRECTION IS ENABLED.
Ø
TO DISPLAY THE CURRENT CF ACCORDINO TO THE POSITION OF THE SCALE
IN THE DIFFERENT SEGMENTS, IT IS POSSIBLE TO USE THE
F30
WITHOUT
ENTERING A NEW VALUE.
Ø
WHEN
F31
IS ENABLED, IT TAKES PRIORITY OVER
F30
, OTHERWISE IT USES
THE PREVIOUSLY PROGRAMMED VALUE OF CF.
Ø
LIKE THE LINEAR CORRECTION, IT TAKES PRIORITY OVER THE OTHER
FUNCTIONS SUCH AS PRE-SET, RESET, ORIGINS, SCALE FACTOR, ETC...
Ø
THE CORRECTION MUST BE ENTERED BEFORE THE OTHER FUNCTIONS
(WHICH OTHERWISE WOULD BE MODIFIED).
Ø
IT IS DISABLED BY ANNULLING THE FUNCTION OR BY RE-PROGRAMMING
THE DIFFERENT POSITIONS ENTERING THE VALUE
CF = 1
FOR ALL OF THEM.
Ø
WHEN PROGRAMMING THE POSITIONS, THE RELEVANT AXIS MUST BE IN
INCREMENTAL COUNTING MODE.
Ø
F31
AND THE PROGRAMMING OF SEGMENTS IS RECALLABLE ONLY IF THE
ALGEBRAIC SUM IS DISABLED (SEE FUNCTION
F28
). ONCE THE
PROGRAMMING IS OVER, ALGEBRAIC SUM CAN BE REACTIVATED.
Ø
ONCE THE BUTTON
COR
IS PRESSED, ALL THE OLD SEGMENTS ARE
DELETED; SO IT IS SO NECESSARY TO COMPLETE IT.
