15 |
P a g e
11. On the motor side of the awning drill a 7/16” hole for the awning motor cable to
enter the RV near the electrical source. Position the hole 1” to the left or right of
the bracket depending on the location of the motor. Do not drill hole higher or
lower than the bracket. This will ensure it will not be seen after the awning is
installed.
12. If you are using a 12V Motion Sensor locate the wire, then drill the
appropriate sized hole to rout the wire to your interior 12V source. Make sure to
seal any perforations made in the shell of the vehicle.
13. Locate the white wire grommet supplied with the awning. Place a fine bead of
silicone around the body of the grommet. Slide grommet into the 7/16” hole
previously drilled for the motor wire.
(FIGURE 3)
Summary of Contents for G-1500
