Gira Control 19, Installation And Operating Instructions Manual

Page: 16 / 21

36
GB
Installing DCS Communicator
To install the DCS Communicator, the installation file of the DCS-IP-gateway must first be
downloaded (see the DCS-IP-gateway operating instructions).

Deactivate write protection.

Copy the corresponding installation file to the Control 19 and run it locally there.

Follow the directions of the installation software for the further installation.

Start the Audio Assistant and follow the instructions.

No other settings then need to be made.
Cancel installation/configuration.

Depending on the firewall setting, the initial start could trigger a security warning.

Confirm the warning with "No longer block", "Allow access".
 Activate write protection.
Installing the QuadClient
The installation file for the QuadClient is located in the HomeServer Expert.
 Deactivate write protection.

Copy the corresponding installation file to the Control 19 and run it locally there.

Follow the directions of the installation software for the further installation.

Start and set the QuadClient Config Editor.
Design 4 = Control 19

Start the QuadClient.

Depending on the firewall setting, the initial start could trigger a security warning.

Confirm the warning with "No longer block", "Allow access".

End the QuadClient again.

Activate write protection.
i
Note
Run the Audio Assistant only when the design frame is mounted.