GIRA
Info
Hand-held radio transmitter
Installation Instructions
Hand-held radio transmitter
15/01
Page: 4 of 10
A
B
C
1
2
3
4
5
1
2
3
4
5
6
7
8
<
>
>
<
Programming of radio transmitters and
receivers
The keys of group or group of the hand-held
radio transmitter can be programmed for any
number of radio receivers.
Important:
In the programming mode, the normal range of
the radio receivers of approx. 100 m (in free
space ) is reduced to approx. 5 m.
Programming a channel key
Procedure
1. Switch the receiver into the programming mode
(see "Radio receiver" operating instructions.
2. Select group A, B or C by depressing the
corresponding key. Depress then the
/\
or
\/
key
of the desired channel (e.g. group C, channel
6) for at least 1 second. The radio receiver
confirms successful storing by an acoustic
signal or by switching of the load.
3. Switch the radio receiver into the operating
mode (see "Radio receiver" operating instruc-
tions).
Channel programming of the key is terminated.
Programming a lightscape key
A lightscape requires several radio receivers
which can be programmed simultaneously or one
after another.
Procedure
1. Switch the radio receiver(s) into the program-
ming mode (see "Radio receiver" operating
instructions).
2.Depress the desired key of lightscape group
(e.g. key 1) for at least 3 seconds. This is con-
firmed by a flashing group LED. The receivers
confirm successful storing by an acoustic signal
or by switching of the load.
3. Switch the radio receiver(s) into the operating
mode (see "Radio receiver" operating instruc-
tions).
Lightscape programming of the key is terminated.
Note the assigned receiver on the supplied label
and stick it on the back of the hand-held trans-
mitter.