Gima 28091, User Manual

Page: 19 / 76

19
Guide and declaration of the manufacturer – Electromagnetic Immunity
The Eolo aerosol can be used in the following electromagnetic environment. The Customer and/or
the user of the Eolo aerosol shall make sure that the appliance is used in such environment.
Immunity test Standard of proof Level of
conformity
Guide to the electromagnetic
environment
Electrostatic
discharge (ESD) -
EN 61000-4-2
± 8kV contact
± 15kV air
The appliance
does not alter
its status
Floors should be in wood, cement
or ceramics. If floors are covered
by synthetic material, the relative
humidity should be at least 30%
Fast transient / burst
EN 61000-4-4
± 2kV power supply
± 1kV signal cables
The appliance
does not alter
its status
The power supply should be that
of a typical commercial premise
or hospital.
Surge EN 61000-4-5 ± 0.5kV e± 1kV
differential mode
The appliance
does not alter
its status
The power supply should be that
of a typical commercial premise
or hospital.
Voltage dips, short
outages and
voltage variations
EN 61000-4-11
5%
U
T (>95% dip
in
U
T) per 0.5 cycle
40%
U
T (60% dip
in
U
T) per 5 cycles
70%
U
T (30% dip
in
U
T) per 25 cycles
<5%
U
T (>95% dip
in
U
T) per 5 s
-- The power supply should be that
of a typical commercial premise
or hospital.
If the user of the Eolo aerosol re-
quires the appliance to work con-
tinuously, it is recommended to
use it with an uninterruptible pow-
er supply.
Network frequency
magnetic field
EN 61000-4-8
30 A/m The appliance
does not alter
its status
The power supply should be that
of a typical commercial premise
or hospital.
Note:
U
T is the value of the supply voltage
Guide and declaration of the manufacturer – Electromagnetic Immunity
The Eolo aerosol can be used in the following electromagnetic environment. The Customer and/or
the user of the Eolo aerosol shall make sure that the appliance is used in such environment.
Immunity
test
Level set out by
EN 60601-1-2
Level of
conformity
Electromagnetic Environment - Guide
Conducted
immunities
EN 61000-4-6
Radiated
immunity
EN 61000-4-3
3Vrms 150kHz
to 80MHz
(for non-life-
supporting appliances)
10 V/m 80MHz to
2.7GHz
(for non-life-equipment
appliances)
V
1
=
3 V rms
E
1
=
10 V / m
Portable and mobile RF communication
devices should be used no closer than the
separation distance from any part of the
Eolo device, including cables, calculated
from the equation applicable to the fre-
quency of the transmitter.
Recommended separation distances
d=
[3.5 /
V
1
]
√P
d=
[12 /
E
1
]
√P
80MHz to 800MHz
d=
[23 /
E
1
]
√P
800MHz to 2,7GHz
P
is the maximum rated output power of
the transmitter in Watt (W) according to
the manufacturer of the transmitter and
d
is the recommended separation distance
calculated in meters (m).
ENGLISH