Gilson PIPETMAN G, Quick Manual

Page: 6 / 12

6
QUICK GUIDE
|
PIPETMAN® G
Fitting the Tips
To fit a new PIPETMAN DIAMOND Tip, push the tip holder
into the tip using a slight twisting motion to ensure a firm,
airtight seal.
PIPETMAN DIAMOND Tip Compatibility
for Multichannel Models
P8x10G, P12x10G D10*, DL10, DF10, DFL10
P8x20G, P12x20G DL10, DFL10, DF30, D200
P8x200G, P12x200G D200, D300, DF200, DF300
P8x300G, P12x300G D200, D300, DF200, DF300
* Using the broad ejector spacer D10, you can adapt a
D10 tip (see above).
PIPETMAN G is equipped with a stainless steel tip
ejector and can also be used with a plastic tip ejector,
available as an accessory. Refer to
PIPETMAN G User’s
Guide LT801122, ACCESSORIES .
Fitting the Tips on P2G and P10G Models
NOTE
For the P2G and P10G models, a dual-position
adapter (plastic) is required to fit DL10 tips
(long tips) or D10 tips (short tips). The metallic rod
of the tip ejector is shaped so the adapter may be
clipped to it in either position.
P2G and P10G models are delivered
with the adapter in place, ready to
use DL10 tips. If D10 tips are used, the
adapter must be repositioned in the
shorter slot as follows:
1.
Pull the adapter down from the
metallic rod.
2. Turn the adapter 180°.
3. Refit the adapter so the end
of the metallic rod engages the
shorter slot of the adapter.
NOTE
Plastic tip ejectors can be
used and ordered separately
(refer to PIPETMAN G User’s
Guide LT801122).
Figure 5
Dual-position
adapter for P2G and
P10G with stainless
steel tip ejector
Short tips Long tips