C
C
A
Move the offset all the way back
Line up the hex rod with the
geared hole in the carriage.
A
B
B
SECTION C-C
SCALE 1 : 8
INSTALLING THE OFFSET CARRIAGES
2x Adults required.
Rotate the hex rod so that the Depth read out
shows 80cm.
Push the offset arm back all the way back.
Remove the top plate and the top bumper stop.
Be careful with the hex rod, there is nothing
supporting it now.
Gently guide the carriage over the upright. The
v-wheels should ride on the corners of the
upright. The hex rod may need to be rotated
slightly to align with the geared hole in the
carriage.
Reattach the top plate and top bumper stop.
It is important to make sure that the correct carriage
is on the correct upright.
With gray support plate facing down, the hole for the hex
rod should be towards the rear of the landing system.
www.gillathletics.com
Copyright
2016 by Gill Athletics.
All rights reserved.
800-637-3090
10/8/2018
INST740110CXXYYSP
Page 10 of 17
740110CXXYYSP - AGX M4 POLE VAULT STANDARDS
INSTRUCTIONS
