GILES GBF-50, Operation & Service Manual

Page: 23 / 111

13
Installation
GBF-50 Fryer
5. If unit is equipped with the optional on ‐ board Oil Top ‐
Off system (not bulk fresh oil), press and momentarily
hold in the ADD OIL PUSHBUTTON ④ on the control
panel. You should hear the top ‐ off pump running.
Release the button and the pump should stop .
6. If either pump does not run or suction is not detected
at the filter pan coupling ② , refer to Section 6.02,
Troubleshooting Procedures , else proceed to next
section.
2.09.3 Filter Pump Test
1. Open cabinet door (unit with filter pan on banked system) . If
needed, disconnect and remove the filter pan from the unit.
2. Place the Oil Return valve ① in the [FILL POT] position
(horizontal).
3. Firmly press the palm of the hand over the Filter Pan Coupling
② on the front brace.
4. While tightly covering the opening, place the
Pump Switch ③ in
the [PUMP] position. The filter pump should start ... if suction is
felt, it is operating correctly. Return switch to [OFF]. Allow pump
to ONLY run long enough to check for suction.
This test confirms that the filter system pump is operating properly.
2
1
3 4
IMPORTANT!
Before using the appliance for the first time, perform the Boil ‐ Out Procedure (all units of a banked system) . This process
will remove residue which may remain from manufacturing processes, or dirt and debris that may have accumulated
during warehousing and shipment. For details concerning the
Boil ‐ Out Procedure see Section 5.01 .
2.09.4 Initial Fryer Cleaning (Boil-Out Procedure)