Gilera Runner 125, Manual, Page: 53 / 80

Rear tail light bulb Type : All glass
Power : 12V - 3W
Quantity : 2
03_26
03_27
Front light group (03_26, 03_27, 03_28)
In order to reach the headlamp bulb remove the snap-on Gilera shield, located on the
front shield, by inserting the blade of a small screwdriver in the corresponding lateral
notch, being careful not to scratch the paint. Then loosen the screw «
A » underneath
and lift up the front shield centre cover.
Then follow this procedure:
High and low beam bulb :
1. remove the rubber cover « B », take hold of the bulb holder and rotate it up-
wards by 30°;
2. disconnect the bulb connector and change the bulb.
Tail lights:
1. remove the rubber bulb holder « C » from its housing, then remove the bulb
and replace it.
53
3 Maintenance