Gilera Fuoco 500, Service Station Manual

Page: 48 / 396

Recommended products
AGIP BRAKE FLUID DOT4 Brake fluid
FMVSS DOT4 Synthetic fluid
Headlight adjustment
Proceed as follows:
- Position the unloaded vehicle, in running order
and with the tyres inflated to the prescribed pres-
sure, onto a flat surface 10 m away from a half-lit
white screen; make sure the vehicle axis is per-
pendicular to the screen.
- Remove the headlight assembly central cover.
- Turn on the headlight and check that the border-
line of the projected light beam should be lower
than 9/10 of the distance from the ground to the
centre of the vehicle's headlight, and higher than
7/10.
- Otherwise, adjust the headlight.
N.B.
THE ABOVE PROCEDURE COMPLIES WITH
THE EUROPEAN STANDARDS REGARDING
MAXIMUM AND MINIMUM HEIGHT OF LIGHT
BEAMS. REFER TO THE STATUTORY REGU-
LATIONS IN FORCE IN EVERY COUNTRY
WHERE THE vehicle IS USED.
To access the headlight adjusting screws:
- Unscrew the four screws « A » (two on each side)
and remove the front cowl.
- Unscrew the four screws « B » and remove the
side cover.
Maintenance
Fuoco 500 i.e.
MAIN - 14