31
Working with the Gigaset N720 SPK PRO
Before you begin
Please note that the measuring devices run on batteries that must be charged before you
start taking measurements. Bear this in mind when planning your time.
You need eight batteries for the measuring base station, provided as a battery pack. The
case contains a charging device for charging the battery pack.
The charging time is
approx. three hours.
You need two batteries for each measuring handset. These can be charged both in the
chargers and in standard charging devices. The charging time in the charger is approx.
8.5 hours.
Setting up the measuring base station
To ensure freedom of movement when measuring and not be dependent on being able
to reach a power connection, operate the measuring base station with external batteries.
The case contains a battery pack with eight integrated batteries and one charging device
for this purpose.
Preparing the base carrier
Please note
Use only the rechargeable batteries (
) recommended by Gigaset Commu-
nications GmbH, i.e., never use conventional (non-rechargeable) batteries, otherwise
serious health risks and personal injury cannot be ruled out. For example, the outer
casing of the batteries could be damaged or the batteries could explode. The phone
could also malfunction or be damaged as a result of using batteries that are not of the
recommended type.
¤
Remove the base carrier from the case
together with the measuring base station
and battery pack.
¤
Slide the lid to the left to open the battery
compartment
§§1§§
.
Lift the lid gently with your fingernail to
get past the lock on the right edge.
¤
Plug the connector on the battery pack
cable onto the two pins on the left side of
the battery compartment
§§2§§
.
Warning:
the connector is shaped so that it
can only be attached the correct way round.
If the connector is forced into the wrong
position, the pins may be damaged render-
ing the device unusable.
1
2
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
