44
Appendix
Gigaset USB Stick 54 / englisch / A31008-M1024-R701-2-7619 / appendix.fm / 07.05.2007
Sc
hablone 200
5_07_
27
You cannot set up a
connection to the
access point.
If you cannot set up a connection between your Gigaset USB
Stick 54 and an access point, try one or more of the following:
ì
Make sure that the physical connection of the access point
operates reliably.
ì
Make sure that the same SSID is used for the Gigaset USB
Stick 54 and the access point.
ì
Check whether the security settings configured for the
Gigaset USB Stick 54 match those for the access point, for
example the same key for WEP encryption.
ì
Check whether your access to the access point is blocked
by other security measures, for example by a MAC filter or
filter for IP addresses.
ì
Make sure that the IP address and the subnet mask are cor-
rectly configured on the
IP settings
tab.
As a rule, it is necessary to assign dynamic IP addresses
when operating a network in infrastructure mode.
Installation can-
celled under
Windows 2000.
If the following error message appears when installing the
Gigaset USB Stick 54 under Windows 2000 "1608:Unable to
create InstallDriver instance" and the installation is cancelled,
the reasons is that the Microsoft Network Client component is
missing.
To install the Microsoft Network Client:
ì
Select
Start
–
Settings
–
Control Panel
–
Network and
Dial-up Connections
.
ì
Right-click on
LAN Connection
and select
Properties
.
ì
Then click on the following
Install
–
Client
–
Add
–
Client
for Microsoft Networks – OK
. The Microsoft Network Cli-
ent component is now installed.
ì
Restart your PC to apply the change.
ì
Install the software, see Chapter "Installing the Gigaset USB
Stick 54" on page 9.
The data transfer
rate seems too low.
ì
If possible, position your PC with the Gigaset USB Stick 54
closer to the access point or remove any visible obstacles.
ì
Re-align the aerials of the access point.
ì
Change the transmission mode of the Gigaset USB Stick 54
and of the access point to 802.11g.
ì
Try another channel. Make sure that the channel setting is
changed on the access point first.
Problem
Causes and remedies
