Gigabyte H262-Z6A, User Manual

Page: 162 / 172

BIOS Setup - 160 -
Before InitMCT 0xA149
Before OtherTiming 0xA14A
Before UMAMemTyping 0xA14B
Before SetDqsEccTmgs 0xA14C
Before MemClr 0xA14D
Before On DIMM Thermal 0xA14E
Before DMI 0xA14F
End of memory code 0xA150
Entry point S3Init 0xA151
Sending MRS2 0xA180
Sedding MRS3 0xA181
Sending MRS1 0xA182
Sending MRS0 0xA183
Continuous Pattern Read 0xA184
Continuous Pattern Write 0xA185
Mem: 2d RdDqs Training begin 0xA186
Mem: Before optional callout to platform BIOS to change External Vref
during 2d Training
0xA187
Mem: After optional callout to platform BIOS to change External Vref during
2d Training
0xA188
Configure DCT For General use begin 0xA189
Configure DCT For training begin 0xA18A
Configure DCT For Non-Explicit 0xA18B
Configure to Sync channels 0xA18C
Allocate C6 Storage 0xA18D
Before LV DDR4 0xA18E
// BR CPU
BR before AP launch 0xA190
Install AP launched PPI 0xA191
BR after AP launch 0xA192
Before CPU PM 0xA193
Enable IO Cstate 0xA194
Enable C6 0xA195
Install CCX PEI complete PPI 0xA196
BR CPU memory done call back entry 0xA197
Before APM weights 0xA198
After APM weights 0xA199
BR CPU memory done call back end 0xA19A
BR Init Mid entry 0xA19B
BR enable APM 0xA19C
BR Init Mid install protocol 0xA19D