Gigabyte H252-Z10, User Manual

Page: 33 / 131

- 33 - System Hardware Installation
3-8 Installing the PCI Expansion Card
• Voltages can be present within the server whenever an AC power source is connected.
This voltage is present even when the main power switch is in the off position. Ensure
that the system is powered-down and all power sources have been disconnected from the
server prior to installing a PCI card.
Failure to observe these warnings could result in personal injury or damage to equipment.
• The PCI riser assembly does not include a riser card or any cabling as standard. To install
a PCI card, a riser card must be installed.
Follow these instructions to install the left PCI Expansion card:
1. Remove the five screws securing the riser bracket to the system.
2. Remove the the screwsecuring the riser bracket to the system.
3. Lift up the riser bracket out of system.
4. Align the PCI-E card to the riser guide slot and push in the direction of the arrow until the PCI-E
card sits in the PCI card connector.
5. Secure the PCI-E card with a screw.
6. Reverse steps 1 - 3 to install the riser bracket back into the system.
1
1
2
3