GIGA-TMS PROMAG TR610, User Manual

Page: 16 / 69

TR610 User's Manual 16
© 2010 GIGA-TMS Inc.
1. You will need to know the netmask and gateway IP used in your network, as well as what IP
address to assign the terminal. If you do not know these settings, find out first from your system
administrator, and then continue with the steps below. Make sure you have these to hand.
2. Scan the master card to go into the onscreen setup.
3. Go to Setup > Network > DHCP and select Disabled.
4. Go back to the Network menu, and go to IP Address.
5. Using the left-side buttons on the device, enter the desired IP address. The system of entering
strings and numbers using the buttons is described here .
6. Go back to the Network menu, and go to Gateway IP. Enter the gateway IP using the same method.
7. Finally, enter the Netmask using the same method.
8. Go back in the menu system and select Reboot in the main menu. The device should now reboot
and show a screen similar to this:
As you can see, DHCP is off, and the IP address you set for the device should appear.
Testing the IP Address
To see if the TR610 is indeed configured and connected to the network, open a web browser (Firefox,
Internet Explorer, etc) and enter the terminal's IP address in the navigation bar. You should get the
Web-
based Setup screen.
The next thing to do would be configuring automatic time synchronization (or just setting the correct
time, if synchronization is not needed).
38
22
17