A-2: Installation in Intel RST Premium With Intel Optane System Acceleration mode
If the SATA controller has been conigured in Intel RST Premium With Intel Optane System Acceleration mode,
please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure
CSM Support
under the
BIOS
menu is disabled.
2. Go to
Peripherals\SATA And RST Coniguration
and make sure
Use RST Legacy OROM
is disabled. If
you want to enable the Optane
™
memory installed in the M2P_32G connector, set
PCIe Storage Dev on
Port 9
to
RST Controlled
; to enable the Optane
™
memory installed in the M2Q_32G connector, set
PCIe
Storage Dev on Port 21
to
RST Controlled
.
3. Enter the operating system, launch the Intel
®
Rapid Storage Technology utility from the Start menu, and then
enable Intel
®
Optane
™
Memory on the
Intel
®
Optane
™
Memory
screen.
4. Follow the on-screen instruction to continue the installation and then restart the system when completed.
•
An Optane
™
memory cannot be used to accelerate an M.2 PCIe SSD.
•
If more than one Optane
™
memory is installed, you can select only one of them to accelerate your
SATA-based boot drive. The other(s) can only be used as data drive(s).
•
Do not abruptly remove the Optane
™
memory. Doing so will cause the operating system to stop
functioning correctly.
•
If you want to change/remove the Optane
™
memory, you must disable it using the Intel
®
Rapid
Storage Technology or Intel(R) Optane
™
Memory application irst.
•
After enabling the Optane
™
memory, the related BIOS settings will remain even after a BIOS update.
- 43 -
Summary of Contents for Z370XP SLI
Page 47: ... 47 ...
