GIGA-BYTE TECHNOLOGY GA-X99-Phoenix SLI, User Manual

Page: 77 / 128

- 77 - Configuring a RAID Set
3-2 Installing the SATA RAID/AHCI Driver and Operating System
With the correct BIOS settings, you are ready to install the operating system.
A. Installing Windows
As some operating systems already include Intel
®
SATA RAID/AHCI driver, you do not need to install separate
RAID/AHCI driver during the Windows installation process. After the operating system is installed, we recommend
that you install all required drivers from the motherboard driver disk using "Xpress Install" to ensure system
performance and compatibility. If the operating system to be installed requires that you provide additional SATA
RAID/AHCI driver during the OS installation process, please refer to the steps below:
Step 1:
Copy the
iRST folder under Boot in the driver disk to your USB thumb drive.
Step 2:
Boot from the Windows setup disk and perform standard OS installation steps. When the screen requesting you
to load the driver appears, select
Browse .
Step 3:
Insert the USB thumb drive and then browse to the location of the driver. The locations of the drivers are as follows:
Windows 32-bit: \iRST\f6flpy-x86
Windows 64-bit: \iRST\f6flpy-x64
Step 4:
When a screen as shown in Figure 1 appears, select
Intel Chipset SATA RAID Controller and click Next to
load the driver and continue the OS installation.
Figure 1