Operating Instructions for ApolloLED 2, 230VAC
21
GIFAS ELECTRIC
• GERMANY • ITALY • FRANCE • AUSTRIA • SWITZERLAND •
www.gifas.com
Initial commissioning / Preparation of the product for regular use
Remove the transport case from the shipping box.
Check the contents of the transport case for completeness using the list above.
Remove any transport safety materials from all components and dispose of them as
well as the cardboard box in an environmentally responsible manner.
Ensure that the air exchange through the light is not blocked by packaging
material.
Regular use on a stand
Setting up the stand, Figure 1
(Fig. see page 8)
Open locking screw “A” (Fig. 1).
Push the stand leg struts to their lowest position and lock screw “A” again.
It is easier to set the stand up by hand if you first loosen screws “C” and “D”.
If the floor is uneven, the stand can be levelled using screw “B”: - Loosen the screw
anti-clockwise - pull the lower part of the stand leg outwards until the wind-up is
standing vertically. - Lock screw “B” in a clockwise direction.
It is important that the stand is set up vertically BEFORE it is loaded up.
Loading the stand
The stand must only be used with the ApolloLED 2. Do not attach any other objects
to the stand.
Only user our approved stand to set up the ApolloLED 2. Do not mount the
ApolloLED 2 onto any other object.
To secure the light to the stand, remove the light from the transport case and attach
the light with the stand support tube to the stand tube from above.
Then connect the mains cable to the light. Ensure that the union nut is fully screwed
onto the cable coupling and is locked in position.
Set the selector switch on the light to the required position:
In position 1
, once the power is connected, 50% of the lights are switched on.
