FlashLED 2
Page 9 / 19
Created
23.09.2019
chal
Modified
04.08.2021
chal
Object-ID
123456
2.3 Responsibilities of the operator
1. Ensure that this document is always stored together with the device.
2. Carefully read this manual before putting the device into operation for the first time.
3. This product has been designed and produced exclusively for the use specified in the documents. Any
other use that is not expressly stated could affect the integrity of the product and/or represent a source
of danger.
4. The manufacturer assumes no liability for damage caused by improper use or usage not according to
the intended use of the product.
5. The product must not be used in environments where there is a risk of explosion. Flammable gases
or smoke constitute a serious safety risk.
6. In addition to Swiss regulations, the standards and regulations applicable in the country of use must
be observed.
7. Installation must be performed in accordance with the valid regulations.
8. The manufacturer accepts no liability in the event of improper installation or in the case of deformation
that may occur during use.
9. Before carrying out any work on the device, the power supply must be switched off.
10. During servicing, only original manufacturer’s parts may be used. Servicing work on the FlashLED 2
light may only be performed by qualified personnel.
11. Any procedure not expressly mentioned by the manufacturer in the instructions is not permitted:
12. Installation of the charging station must be performed in accordance with the valid regulations:
13. The packaging materials (plastic, polystyrene, etc.) should not be stored within reach of children.
Hint
Although the FlashLED 2 lamp has been designed for harsh environments, it must be ensured that it is used
according to the IP67 protection standard to prevent damage and malfunctions.
It should also be ensured that the loading station of the FlashLED 2 lamp is operated in a dry place according
to its protection standard (IP44).
2.4 Start-up
Caution
To start-up please insert the lamp into the charging station and charge the battery completely.
If FlashLED is put on stock for more than 3 month, you need to reactivate the energy-saving mode to protect
from deep discharge. Otherwise the battery pack will be seriously damaged.
