Gibson 2010 Les Paul Standard LTD ED, Owner'S Manual

Page: 25 / 37

Gibson LP STD LTD Manual v1.0 Page 25
2. While in the Red Bank, rotate the MCK to the A position.
3. Push Enter for more than one second; the outer string LEDs will shine red.
4. Rotate the MCK to the string position corresponding to the string you want to tune up. The
string LED will shine blue.
5. Push Enter briefly on the MCK, and the string will be tuned up in pitch by approximately five
semitones.
6. If necessary, tune up other strings as well.
7. When the strings have some degree of tension on them, push Enter for more than one
second to exit single string up mode.
8. To choose a tuning for finalizing the tuning process, select the Blue or Yellow Bank
(whichever has the desired tuning) by initiating a series of brief, successive pushes on Enter
until the Blue or Yellow Bank appears.
9. Tune Les Paul Standard 2010 Limited normally.
Note:
●
If a string is very loose, it may short out to a different string, or a different RoboHead tuner.
The MCK will advise you of this condition by showing the string LED in white. Tune the string up
manually until it no longer shorts out, then proceed as described above.
5.9 Yellow Bank User Bank Selection (Position = G, ID = U)
The Yellow Bank has eight User Banks, each of which has 11 presets. When you select the Yellow Bank,
it defaults to whatever User Bank has been selected using this function (if no User Bank has ever been
selected, the Yellow Bank defaults to User Bank 1).
5.9.1 Selecting a Yellow Bank User Bank Step ‐ by ‐ Step
1. Choose the Red Bank by initiating a series of brief, successive pushes on Enter until the Red
Bank appears.
2. While in the Red Bank, rotate the MCK to the G position.
3. Push Enter for more than one second; the Display Matrix shows the currently selected User
Bank in yellow.
4. Rotate the MCK to select the desired User Bank (1 ‐ 8). The outer LED that corresponds to the
bank you've selected will shine blue. If you turn the MCK to an invalid position (i.e., above 8),
the Display Matrix shows “X.”
5. After selecting the desired User Bank, push Enter briefly to activate the User Bank. The
Display Matrix shows the User Bank number in green briefly before exiting to the Red Bank.
Now when you select the Yellow Bank, the outer LED that corresponds to the selected User
Bank will shine yellow, and remain selected until you repeat the above procedure to select a
different User Bank.
Chapter 6: Red Bank Setup Functions