Giant LP200-SS, Operating Instructions/ Repair And Service Manual

Page: 3 / 12

3
U.S Metric
Volume .......................................................................................... 19.0 GPM ..................................... 72.1 LPM
Discharge Pressure ...................................................................... 3000 PSI ......................................... 200 Bar
Inlet Pressure ............................................................................... -4.35 to 90 PSI ...................... -0.3 to 6.2 Bar
Speed ...................................................................................................................................... Up to 1000 RPM
Plunger Diameter .......................................................................... 1.10” .................................................. 28 mm
Stroke ............................................................................................ 1.65” .................................................. 42 mm
Crankcase Oil Capacity ................................................................ 118 fl.oz. ................................................ 3.5 L
Temperature of Pumped Fluids @ 1000 RPM ............................... 140
o
F ................................................ 60
o
C
Temperature of Pumped Fluids @ 500 RPM ................................. 160
o
F ................................................. 70
o
C
Inlet Port .................................................................................................................................... (3) x 1-1/4” BSP
Discharge Port ................................................................................................................................. (3) x 1” BSP
Crankshaft Mounting ......................................................................................................................... Either Side
Shaft Rotation .................................................................................................... Top of Pulley Towards Fluid End
Weight .......................................................................................... 119 lbs. ................................................ 54 kg
Crankshaft Diameter ................................................................................................................................ 35 mm
Manifold Material .................................................................................................................... 303 Stainless Steel
Model LP200-SS Specifications
HORSEPOWER INFORMATION
We recommend that a 1.1 service factor be speci-
fied when selecting an electric motor as the power
source. To compute specific pump horsepower
requirements, use the following formula:
HP = (GPM X PSI) / 1440
PULLEY INFORMATION
Pulley selection and pump speed are based on
a 1725 RPM motor and “B” section belts. When
selecting desired GPM, allow for a ±5% tolerance
on pumps output due to variations in pulleys, belts
and motors among manufacturers.
1. Select GPM required, then select appropriate
motor and pump pulley from the same line.
2. The desired pressure is achieved by selecting
the correct nozzle size that corresponds with the
pump GPM.
RPM GPM 1000 PSI 1500 PSI 2000 PSI 2900 PSI
500 9.5 6.6 9.9 13.2 19.1
640 12.2 8.4 12.7 16.9 24.5
750 14.3 9.9 14.8 19.8 28.7
805 15.3 10.6 15.9 21.2 30.8
865 16.4 11.4 17.1 22.8 33.1
920 17.5 12.1 18.2 24.3 35.2
1000 19.0 13.2 19.8 26.4 38.3
LP200 HORSEPOWER REQUIREMENTS