3
unit assembly
6
Vac Belt Installation - All Models
Install Z-vac drive belt onto top tier of vac drive
pulley. Be sure belt runs through vac idler sys-
tem correctly; also be sure there is no belt
rollover.
Note: Pull back tension release lever on idler
arm (see inset) to give extra belt slack when
installing.
Belt Guard Installation - All Models
(61” shown)
Install Vac Drive belt guard using existing rider
hardware. Tighten securely.
Install vac unit pulley guard (inset) with three
5/16-18 x 3/4” ‘F’ thread bolts. Tighten secure-
ly.
Vac Unit Installation - All Models
(61” shown)
Fit Z-Vac unit into place over and against
mower discharge, aligning holes in discharge
mounting brackets with holes in Z-vac mount-
ing bracket. Insert one 3/8 x 2” clevis pin into
each of the two mounting holes, securing with
bridge pins.
Lock unit firmly in place with T-bolt as shown.
GVTP ZVBB-R0203.1
