Discharge Hose Installation - All
Models (3 Bag Unit shown)
Slip one hose clamp onto each end of hose (use the
clamp with the quick-release knob at the blower
end), and install hose between unit and bagger,
making careful note of direction sticker inside end of
hose (see inset). Tighten clamps securely.
Note: On 2 bag units, be sure to slip middle of hose
length into cradle of Discharge Hose Standoff, in
order to prevent hose from hitting rear wheel of
rider.
unit assembly
3
13
Assembly is complete. Refer to the operator’s manual of your rider for the
safest and most effective use of your new unit.
SOME IMPORTANT DO’S AND DON’TS FOR SAFE AND EFFECTIVE OPERATION:
DO...
...Inspect unit before each use to be sure all fasteners are securely tightened
and all components are securely in place.
...Be aware that installed blower unit engages along with mower deck - never
operate mower without hose, cover and bags in place.
...Inspect unit often for wear and damage. Replace worn or damaged items
promptly.
...Grease bearing units regularly with a quality lithium grease.
DO NOT...
...Operate the rider without the weight channel and bars installed. Rear tipping
of rider can result.
...Operate the unit without belt guards securely in place. Serious injury may
result.
...Overfill bags. A good rule of thumb is to empty bags at about 3/4 capacity.
...Store unit with bags full. Stretching and eventual tearing of bag material may
result.
GVTP ZVBB-R0203.1
