Assemble the upper reinforcement brace as
shown, using two 3/8-16 x 1-1/4” hex bolts,
each fitted with one 3/8” flat washer, and
secure with two 3/8-16 serrated flange nuts.
Do not tighten hardware.
Install the reinforcement brace assembly onto
the unit, utilizing the square holes in the
engine base. Secure with four 5/16-18 x 3/4
carriage bolts (inserted up from under the
engine base) and serrated flange nuts. Note:
Do not tighten brace hardware until support
assembly in following steps is installed.
3
unit assembly
Bagger Unit Installation - 3 Bag Units
(Cont.)
Hook bumper mount plate onto rear bumper,
making sure one bar clamp is in front of
bumper, another behind. Secure in place with
same hardware in lower set of holes as in pre-
vious step. Do not tighten yet.
Repeat the same for the bottom part of the
mount, using the long clamp bar, one on the
inside and one on the outside of the bumper.
Insert two 3/8-16 x 1-3/4” bolts from the
bumper mount side, securing with two 3/8 flat
washers and two 3/8-16 nylon lock nuts.
Tighten securely.
10
GVTP ZVBB-R0203.1
