12
•
THROTTLE CABLE ADJUSTMENT:
Correct cable
adjustment allows for full range of movement of throttle
body on engine in conjunction with throttle control on
handle. To adjust:
Intek Engines:
Loosen cable clip screw on engine, then slide cable
housing in or out in approximately 1/8-1/4” increments.
Retighten screw, recheck, and readjust as needed.
Vanguard Engines:
Loosen cable clip screw on throttle linkage. (NOTE:
View is from above engine.) Move cable in (to the left)
or out (to the right) in approximately 1/8-1/4” incre-
ments. Retighten screw, recheck, and readjust as
needed.
•
FRONT WHEEL CAMBER ADJUSTMENT:
Correct
camber adjustment will place the front axle at 0
degrees, or parallel with level ground, and the wheel at
90 degrees or perpendicular with level ground. Adjust
by loosening the three mounting bolts and placing a
square aside the wheel and adjusting until square sits
flat on ground and touches upper and lower points of
tire, then retightening bolts. An alternate method is to
place a level against the side of the caster bracket.
5
maintenance (cont.)
BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG
WIRE TO PREVENT INADVERTENT STARTING OF UNIT.
!
ADJUSTMENTS:
REPLACEMENT PARTS:
•
Replacement parts are available through your dealer
.
90
O
0
O
MOVE CABLE
LOOSEN LINKAGE
SCREW
LOOSEN SCREW
MOVE CABLE
Summary of Contents for Whisper-Jet LBWJ10172BV
