2. Edit Satellite
This menu used to configure the satellite setting.
TP: press the right arrow key to move the highlight
to the tp list and then select the tp that you want.
LNB: select the correct LNB type that you have on
your dish. You also can define frequency by "User
Mode".
22K: set the 22K on or off.
12v: set the 12v on or off
DisEqc 1.0: Select the correct port up to 4 LNB
DisEqC 1.1: Select the correct port up to 16 LNB.
Motor: Select the correct motor mode
Power: Set LNB power ON or OFF
Scan: Press
key to open the channel search
windows.
Motor: Press
key to select a proper motor mode
Motor DiSEqC 1.2
This mode will allow you to set the antenna position for
each satellite. In order to use antenna positioner you
must use a motor controlled by DiSEqC 1.2 commands.
To move the antenna, you need first set your desired
move limit, then select the move dish by continue or step
size and press the ok key to start move the antenna West
or East. If you selected Continuous for the move mode,
the antenna will move continuously until you press
another key. Once the antenna is positioned properly,
select save option and press ok key to save the position.
Goto reference used to move the dish to 0 positions.
Motor USALS
This mode will allow you to use a DiSEqC 1.3/2.3
motor controlled by USALS (Universal Satellite Automatic
Location System). At first, you need edit the satellite’s
position (longitude and latitude). Then select move
option and press the OK key move the dish to the
satellite’s position.
Goto reference used to move the dish to 0 positions.
When switch through the satellite list, the dish will start
to move that has the Positioned Setup set to DiSEqC 1.2
or USALS (assuming that a DiSEqC 1.2 or USALS motor is
connected to your dish). You can avoid this by returning
the Motor the OFF state.
Auto Diseqc: Press
key to automatic find the
satellite in which diseqc port.
