50
GHOST EPAC
1.
Insert the mains plug of the charging device into the socket (F).
The green indicator lamp goes on.
The charge status is shown in the display.
WARNING If the display light does not go on,
the charging device might be damaged.
·
Remove the mains plug from the socket (F).
·
Do not use the charging device any more.
·
Contact your specialist bicycle dealer.
2.
Insert the plug of the charging cable into the socket (D) of the rechargeable battery pack.
The rechargeable battery pack is now being charged up.
The display goes off when the rechargeable battery pack is fully charged.
NOTE:
When the battery pack is charged up for the first time the charging time is considerably
longer than the average charging time of 4 – 5 hours.
3.
Remove the plug of the charging cable from the socket (D) on the rechargeable battery
pack.
4.
Remove the mains plug from the socket (F).
NOTE:
You can leave the rechargeable battery pack permanently connected to the charging device for as long as
you do not use the EPAC. This increases the service life of the rechargeable battery pack, but also increases
your electricity consumption.
8.9.9
Calibrating the electric drive
Calibrate the electric drive if the pedalling assistance no longer provides the desired power.
1.
Place the EPAC on the ground.
2.
Stand next to the EPAC.
3.
Turn the lights off.
4.
Turn the pedalling assistance to 0 (OFF) in the display.
5.
Press the M button for 5 seconds until
-0-0- is shown in the bottom line of the display.
The EPAC is calibrated.