HD50CR
- 17 -
V1.0
If the logging interval is greater than the measuring interval, the average of the
measurements acquired during the logging interval will be stored.
The “Erase Memory” button allows erasing the data in the instrument memory.
•
ALARMS panel
Setting of the alarm thresholds and buzzer operating mode for each of the available
quantities. The hysteresis, in percentage of the difference between the two alarm
thresholds, and the delay time (set “no delay” for immediate activation in the event of
an alarm) of the alarm can be configured.
Logging
interval
Measuring
interval
Press “Apply” to send the
changes to the instrument
Cyclic: cyclic overwriting of the memory
NO Cyclic: logging is stopped when the memory is full
Button to erase the memory
Button to refresh
the settings
Active: logging is active
NO Active: logging is not active
Press “Apply” to send the
changes to the instrument
Lower threshold
Upper
threshold
Button to refresh
the settings
Alarm hysteresis
Alarm delay
Send e-mail if the upper
threshold is exceeded
Send e-mail if the lower
threshold is exceeded
Enable lower threshold
Enable buzzer
Enable “Latch” function
Enable upper
threshold
Buzzer
silencing time
Summary of Contents for Delta OHM HD50CR
Page 44: ...HD50CR 44 V1 0 Dimensions mm...
Page 49: ...HD50CR 49 V1 0 NOTES...
Page 50: ...HD50CR 50 V1 0 NOTES...
Page 51: ......
