www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
EN
- 19
12.1.g - Cleaning the clean water fil-
ter (Fig. 21)
- Make sure that the tank (13) is empty.
- Remove the cap (22) and take out the fil-
ter cartridge (64).
- Clean the filter cartridge (64) using run-
ning water.
- Reassemble everything proceeding in re-
verse making sure that the gasket (65) is
placed correctly.
12.1.h - Replacing the squeegee rub-
ber blades (Fig. 22)
When it becomes clear that drying the floor
is difficult or traces of water remain on the
floor, it is necessary to check the wear on the
squeegee rubber blades (20):
- Remove the squeegee unit (20) as indi-
cated in the “Cleaning the squeegee” par-
agraph.
- Loosen the finned nuts (67) and remove
the rubber blades (60).
NOTE:
When the rubber blades (60) are worn on
one side, on one occasion they may be
turned over.
- Replace or turn over the rubber blades
(60) without inverting them.
- Replace all the components in reverse
order.
NOTE:
Two types of rubber are available:
Para rubber for all types of flooring and poly
-
urethane rubber for workshop floors with oily
residues.
12.1.i - Replacing the side skirt
rubbers (Fig. 23)
When it becomes clear that the washing
water is not well held by the side skirts, it is
necessary to check the wear status of the
rubbers (62):
- Remove the side skirts as indicated in the
“Cleaning the side skirts” paragraph.
- Unscrew (68) and remove the rubbers
(62).
NOTE:
When the rubber blades (62) are worn on
one side, on one occasion they may be
turned over.
- Replace or turn over the rubber blades
(62) without inverting them.
- Replace all the components in reverse
order.
12.1.j - Adjusting the pressure of the
squeegee (Fig. 24)
- Start up the machine and press the (40
Fig. 9) “
” button.
The wiper unit will be lowered.
- Engage the forward motion and move
by a few meters, then get out of the ma-
chine.
- Use the threaded bar (69) to adjust the
squeegees’ (60) contact with the floor.
Turn it clockwise for increased contact
and counter clockwise for less contact.
NOTE:
When the squeegee is making proper con
-
tact with the floor, there will be no streaking
on the floor during machine function and the
entire length of the squeegee will be in con-
tact with the floor.
00_Manu_RUNNER_1ed 10-2020 - 49029500.indb 19
00_Manu_RUNNER_1ed 10-2020 - 49029500.indb 19
16/10/2020 08:15:40
16/10/2020 08:15:40
