www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
ENGLISH
- 3
- For very dirty areas it is recommended
you apply detergent to the dirty area with-
out suctioning it; leave the detergent al-
lowing it to work for several seconds and
then wash the area and suction the dirt.
NOTE:
To prevent the detergent pump from break-
ing, it is recommended that you stop its op-
eration, pushing the relative switch, when
dosing has not occurred for several minutes.
NOTE:
When the recovery tank is full, noise in-
creases and the appliance does not suction;
therefore, switch it off and empty the tank as
described in the relevant paragraphs
Switching off the appliance
- Press the switches (24 and 25 Fig. 16) to
“0” to switch off the appliance; the lamps
on the switches will go out.
- Remove the plug (23 Fig. 15) from the
electrical socket.
CLEANING AND
MAINTENANCE
DANGER:
Before performing any maintenance op-
erations, unplug the appliance from the
electrical socket.
Daily cleaning
Emptying the recovery tank
- Position yourself over a floor drain with
the appliance.
- Detach the drain hose (28 Fig. 19) from
its relative support.
- Unscrew the knob (29 Fig. 19) and re-
move the cap (30 Fig. 19) of the water
drain hose (28 Fig. 19) and empty the liq-
uid into the recovery tank (31 Fig. 19).
Cleaning the detergent dosing circuit
At the end of each workday, clean the de-
tergent dosing circuit as follows to prevent
clogging:
- Release pressure from the circuit by
pressing, with dosing pump off, the lever
(27 Fig. 18) or lever (26 Fig. 17)
- Disconnect the detergent delivery hose
(4 Fig. 3).
- Lift up the levers (32 Fig. 20) and remove
the cover (33 Fig. 21) complete with mo-
tor.
- Disconnect the detergent suction hose (6
Fig. 4).
- Remove the detergent container (36 Fig.
22) lifting it by the dedicated handle (40
Fig. 22).
- Empty the remaining liquid into a suitable
container.
- Wash the inside of the detergent contain-
er with running water.
- Put the detergent container back in place,
attaching it to the dedicated bracket (41
Fig. 22) fixed to the tank.
- Connect the detergent (6 Fig. 4) suction
hose to the quick coupling (7 Fig. 4).
- Pour clean water into the detergent con-
tainer, electrically connect the appliance
and start the dosing pump by pressing
the switch (25 Fig. 16).
- Clean the circuit by pressing the lever (27
Fig. 18) or (26 Fig. 17), depending on the
type of mouthpiece.
- Dispense the liquid from the nozzle until
clean water comes out.
- Empty the water in the detergent tank as
described above.
Cleaning the appliance body
- Clean the unit body with a cloth damp-
ened with water or a mild detergent.
- Remove the cover as indicated previous-
ly and clean the inside of the tank with
running water, leaving the drain hose
open (28 Fig. 23) then reassemble eve-
Manuale M26_8050832_1ed_04-2017.indd 3
26/04/17 17:05
