GGMgastro WKM335SN, User Manual

Page: 6 / 16

ENG
5
2. OPERATION OF THE DEVICE
2.1 SETTING AND INSTALLING
Before installing the device, it must be delivered to the target place of work. Remove the protec-
tive foil from the device’s components.
After setting the device, it should be leveled. To do this, screw in or unscrew the feet of the
device. Accurate horizontal positioning of the rack prevents noisy operation and ensures
proper water drainage during defrosting.
After setting up the device, you must provide access to the power cord plug. It is not al-
lowed to place the refrigeration device in the immediate vicinity of the elements that emit
large amounts of heat (radiators, air heaters, etc.)
Inside the chamber for storing food products, you must not use electrical appliances of
a different type than those recommended by the manufacturer. Protect the refrigeration
circuit against damage.
After unpacking and setting the device and before it is put into operation, the first wa-
shing should be carried out. The water used for washing should not exceed 40ºC with the
addition of neutral cleaning agents. It is forbidden to use agents containing chlorine and
sodium of different varieties, these agents can destroy the protective layer and compo-
nents of the device!
When cleaning the device, you can not use a water jet. The device should be washed
using a damp cloth.
The device should be left at rest for at least 2 hours after the completed installation before it is
turned on (applies to devices with an internal unit), then the oil level is leveled and it prevents
problems with the start-up of the refrigeration unit!
In devices with an internal unit special attention should be paid not to block the inlet holes in the
aggregate chamber (perforation in the lower part of the rack), used for cooling the air of the unit.
Accurate horizontal positioning of the rack prevents noisy operation and ensures proper water
drainage during defrosting.
Users manual - Wall cooling shelf