Gfp 865DH
February 2018
23
20.
Operation
1.
General operation
•
Turn power to “ON” with the rear power switch, Power light on control will illuminate
•
Select temperature and speed settings
•
Wait until rollers reach desired temperature displayed on LCD
•
Adjust desired roller pressure
•
Depress Run switch for continuous operation
2.
Cold laminating
•
When doing cold laminating, turn both temperature dials counter clockwise to turn off
heaters
•
Adjust speed dial to desired position
3.
Top Heat Laminating
•
Rotate TOP heater dial counter clockwise to turn on top heater only
•
Select desired temperature setting
•
Recommended temperature setting for most applications with PSA film is dial setting
2 for approximately 100° F
•
Recommended speed setting is dial setting 2 for 5 ft./min
4.
Thermal Laminating (Encapsulation)
•
Turn both temperature dials clockwise to turn on both top and bottom heaters
•
Select desired temperature and speed settings
•
Recommended temperature settings
a.
Low temperature film (activation temperature 185° F) - Dial setting 4 = 200° F
b.
High temperature film (activation temperature 210° F) - Dial setting 5 = 230° F
•
Recommended speed settings
Film gauge
Dial
ft./min
1.5 mil
4
8
3.0 mil
2.5
6
5.0 mil
2
5
10 mil
1.5
2.5
NOTE:
•
Recommended settings are starting points only and should be adjusted according to
quality of output achieved.
•
Excess heat may damage the printed image or cause waves. Insufficient heat may
result in delamination.
•
Thinner stocks can be run faster, and thicker stocks or heavy ink coverage should be
run slower.
•
Some stocks and ink-sets cannot be effectively laminated with thermal films.
Compatibility testing is recommended before laminating long runs.
NOTE: The surface temperature of the rollers is shown on the LCD readout. The LCD
does not work when the heaters are turned off